Control Panel; Remote Control; Before Initial Use - DS Produkte 05110 Mode D'emploi

EN

Control Panel

9 10
19

Remote Control

24
23
22

Before Initial Use

1. Before using the device for the fi rst time, remove all packaging materials and any
labels that may be on the device and are used for protection during transportation or
for advertising. Never remove the rating plate or any possible warnings.
2. Insert the battery into the remote control (see "Inserting / Changing Battery in the
Remote Control").
Inserting / Changing Battery in the Remote Control
Before inserting the battery, check whether the contacts in the remote control and on the
battery are clean, and clean them if necessary.
1. Unscrew the battery compartment on the back of the remote control by using a coin
or similar item to turn it towards OPEN.
2. Take out the used battery and insert a new battery (3 V, CR2025 type). The positive
pole must be facing upwards.
3. Insert the battery compartment cover and twist it towards CLOSE to close it.
Replace the battery when the power of the remote control starts to wane.
11 12 13
18 17
20
21
18
9 : Stand-by on / off
14 15
10 ON : Start
11 Timer / programme display:
Remaining time in minutes, active
programme
12 Receiver (remote control)
13 Display of
14 OFF : Stop
15
16
16 SPEED + : Increase vibration level
17 SPEED – : Reduce vibration level
18 TIME + : Increase workout time
19 TIME – : Reduce workout time
20 Increase vibration level
21 P Programme button
22 Reduce vibration level
23 Start / Stop
24 Stand-by on / off
speed: vibration level
: Programme selection