Technical Data; X 20 V Team - Parkside Part 20-Li A1 Traduction Des Instructions D'origine

Please refer to the descriptions below
for information on how the operating
elements work.

Technical data

Cordless Grass Trimmer
.................................... PART 20-Li A1
Rated voltage U
........................ 20 V ⎓ (Direct voltage)
Weight with battery (20 V, 2 Ah)
.................................................≈1.9 kg
No-load rotation speed n
Protection type ............................IPX0
Cutting circle ..................... Ø 240 mm
Spool
– Line thickness .................. Ø 1.4 mm
– Line length ................................. 4 m
Sound pressure level (L
...............................60.3 dB; K
Sound power level (L
– Measured ..... 86.3 dB; K
– Guaranteed ............................ 96 dB
Vibration (a )
h
– Handle ........ 1.048 m/s²; K=1.5 m/s²
– Auxiliary handle
....................... 1.111 m/s²; K=1.5 m/s²
Battery .......................................Li-Ion
Temperature ............................ ≤50 °C
– Charging ........................... 4 – 40 °C
– Operation ......................−20 – 50 °C
– Storage ............................. 0 – 45 °C
PARKSIDE Performance Smart
battery Smart PAPS 204 A1/
Smart PAPS 208 A1/
Smart PAPS 2012 A1
– frequency band .. 2400–2483.5 MHz
– transmitted power ............≤ 20 dBm
Levels of noise and vibration were de-
termined according to the standards
and regulations in the declaration of
conformity.
The specified total vibration value and
the stated noise emission value have
−1
8500 min
0
)
pA
=3 dB
pA
)
WA
=2.47 dB
WA
been measured according to a stand-
ardised test method and can be used
to compare one power tool with an-
other. The specified total vibration
value and the stated specified noise
emission value can also be used for a
provisional assessment of the load.
WARNING! The vibration and
noise emissions may deviate from
the specified values during actual
use of the power tool, depending on
how the power tool is being used. Try
to keep the exposure to vibrations
as low as possible. An example of a
measure to reduce vibration expos-
ure is limiting the working hours. All
parts of the operating cycle have to
be considered while doing so (for ex-
ample, times when the power tool
is switched off and times when it is
switched on but running without any
load).
X 20 V TEAM
The device is part of the
X 20 V TEAM series and can be
operated with batteries of the
X 20 V TEAM series. Batteries of
the X 20 V TEAM series may only
be charged using chargers of the
X 20 V TEAM series.
We recommend that you oper-
ate this appliance with the fol-
lowing batteries only: PAP 20 B1,
PAP 20 B3, Smart PAPS 204 A1,
Smart PAPS 208 A1,
Smart PAPS 2012 A1
We recommend charging these bat-
teries with the following chargers:
PLG 20 A3, PLG 20 A4, PLG 20 C1,
PLG 20 C2, PLG 20 C3, PLG 201 A1,
PDSLG 20 A1, PDSLG 20 B1,
Smart PLGS 2012 A1
Rechargeable battery and charger
technical data: See separate manual.
GB MT
23