Using The Memory - uebe Visomat handy express Mode D'emploi

C
symbol in the display. Other disruptive factors such as speaking,
coughing or cuff noises can cause the symbol to be displayed. If
this symbol appears, please repeat the measurement and avoid
the disruptive factors.
The symbol is stored with the respective measurement.

15. Using the memory

The device stores the measured values in two memories (one per
user). Each memory can store up to 120 readings and the aver-
age value (A). The average value is calculated from the last three
measurements taken.
The measured results are automatically saved in the memory. If
more than 120 measured values are saved, the oldest measured
value (no. 120) is deleted so that the latest value (no. 1) can be
recorded.
Data retrieval
Set the user whose data you wish to retrieve.
To retrieve data, press the Memory button
of the user you wish to retrieve the data for
while the device is switched off. The average
value of the last three measurements is dis-
played along with an "A" (Figure 1).
Press the Memory button again to display the most recently
measured values (Figure 2). If the date/time function is activated,
the memory number (Figure 2), the date (Figure 3) and the time
(Figure 4) are displayed alternately.
EN-52
Operating the device
Figure 1
Operating the device
Figure 2 Figure 3
Press the Memory button repeatedly to recall further measured
values.
You can switch between the two memories by pressing Memory
button 1 or 2.
The stored data remain visible in the display for around 30 sec-
onds. The device then switches itself off.
Deleting data
To delete individual measured values, recall the measured value
you wish to delete.
Press the Memory button again and hold
down until the display firstly flashes and is
then replaced with dashes.
To delete the entire memory, retrieve the
respective average value (A), press the Mem-
ory button again and hold down until the
average value firstly flashes and is then re-
placed with dashes.
C
Figure 4
EN-53