Irregular Pulses And Cardiac Arrhythmia; Using The Memory - uebe visomat comfort XXL Mode D'emploi

C
The WHO classification is stored along with the measured values
and both can be recalled from the memory.
Depending on age, weight and general health, the blood pressure
values can be different. Only a doctor can determine the right
blood pressure range for you and assess whether your blood
pressure has reached a dangerous level for you. Discuss your
blood pressure values with your doctor.
Never change the dose of medicines prescribed by your doc-
tor!

12. Irregular pulses and cardiac arrhythmia

If the device detects irregular pulses during the
measurement, the symbol is displayed once the
measurement is complete.
This can be triggered by cardiac arrhythmias, move-
ment, talking or even by deep breathing. The symbol
is stored with the respective measurement.
A more frequent appearance of the symbol may indicate cardiac
arrhythmia and must be discussed with your doctor! Measure-
ment results accompanied by irregular pulses should be viewed
as critical and repeated under more favourable conditions.
The device must not be used in place of a cardiac exam; it is only
intended for early detection of an irregular pulse.

13. Using the memory

The device stores the measured values in two memories (one per
user). Each memory can store up to 60 readings and the average
value (A).
EN-48
Operating the device Operating the device
The measured results are automatically saved in the memory. If
more than 60 measured values are saved, the oldest measured
value (no. 60) is deleted so that the latest value (no. 1) can be
recorded.
Data retrieval
Set the user whose data you wish to retrieve (see page 46).
To retrieve data, press the MEMORY button. The
average of the saved results will be indicated by an
"A", followed by the number of saved readings from
which the average was calculated (Figure 1).
Press the Memory button again to display the most
recently measured values (Figure 2). If the date/time
function is activated, the memory number (Figure 2),
the date (Figure 3) and the time (Figure 4) are displayed alter-
nately.
Figure 2 Figure 3
Press the Memory button repeatedly to recall further measured
values.
Deleting data
To delete individual measured values, recall the measured value
you wish to delete.
Press and hold the MEMORY button again until the reading flash-
es several times and then goes out.
C
Figure 1
Figure 4
EN-49