Using The Memory; Transferring The Data To A Pc - Uebe Visomat Double Comfort Mode D'emploi

C

12. Using the memory

The unit has two measured value memories (one per user), each with 60 storage
locations and average value display (A). Measured results are automatically stored
in the memory. If more than 60 measurements are saved, the oldest value (No. 60)
is deleted to make way for the latest value (No. 1).
Recalling data
Press the MEM memory recall button. The
memory display appears and the two user
numbers flash. Press Start/Stop 1 button or
Start/Stop 2 button to select the user whose
memory values you wish to recall. Fig. 1
The average values of the stored results are
shown with "A", the values for systole, dias-
tole and pulse and the pulse pressure (PP)
are shown in alternating sequence in the
display. Fig. 2
Press the MEM button again to display the
value (No. 1) last measured. Systole, dias-
tole and pulse are displayed in alternating
sequence with the memory number (Fig. 3)
and date (Fig. 4), then the pulse pressure
(PP) with the time (Fig. 5). Press the MEM
button repeatedly to recall further measured
values.
The stored data are visible in the display for
about 30 seconds. The unit then switches off
automatically.
EN-64
Operating the unit
Fig. 1 Fig. 2
Fig. 3 Fig. 4
Fig. 5
Operating the unit
Deleting data
To delete individual values, press the memory recall button several times to obtain
the measured value required. Press the MEM button again and hold it until the
value first flashes and then is replaced by dashes.
To delete the entiry memory for a user, recall the relevant average value display (A)
and press the MEM button again, holding it down until the mean value first flashes
and is then replaced by dashes.
If no value is stored, dashes are shown.

13. Transferring the data to a PC

The unit features a USB interface. Using the USB connecting cable provided and
the visomat evaluation software, you can transfer the measured values from the
®
blood pressure monitor to your PC for evaluation.
If the blood pressure monitor is to be connected to external equipment, make sure
that this equipment conforms to the latest safety standards (e.g. IEC 60950).
C
EN-65