Scheppach MBS1200 Traduction Des Instructions D'origine page 19

17. Troubleshooting
Fault Possible cause
Motor does not work Engine, cable or connector defective,
fuses burnt.
The engine runs slowly Voltage too low, coils damaged,
and does not reach the capacitor burnt.
operating speed.
Motor makes excessive Coils damaged, motor defective
noise
The motor does not Circuits in the network are overloaded
reach its full power. (lamps, other motors, etc.)
Motor overheats easily. Overloading of the motor, insufficient
cooling of the motor
Saw cut is rough or Saw band dull, tooth shape not appro-
wavy. priate for the material thickness
Workpiece pulls away Excessive cutting pressure and/or
and/or splinters. saw band not suitable for use.
Burn marks on the Saw band blunt.
wood when working.
Incorrect speed.
Saw band jams when Saw band blunt.
working.
Saw band resinous.
36 | GB www.scheppach.com
Remedy
Have the machine checked by a specialist.
Never repair the engine yourself.
Danger! Check the fuses and replace them if
necessary.
Have the voltage checked by a utility provider.
Have the engine checked by a specialist.
Have the capacitor replaced by a specialist.
Have the engine checked by a specialist.
Do not use any other equipment or engines on
the same circuit.
Avoid overloading the engine while cutting.
Remove dust from the engine in order to
ensure optimal cooling of the engine.
Sharpen the saw band or insert a suitable saw
band.
Insert a suitable saw band.
Replace the saw band.
Choose a suitable speed for the workpiece to
be cut.
Replace the saw band.
Clean the saw band.
Explication des symboles sur l'appareil
Avertissement ! Danger de mort et risque de blessures et d'endommagement de la machi-
ne en cas de non respect des instructions.
Lire la notice d'utilisation et observer les consignes de sécurité avant de procéder à la
mise en service !
Portez des lunettes de protection !
Portez une protection auditive !
Portez un masque anti-poussière !
Attention ! Risque de blessure ! Ne pas toucher la ruban de scie en marche !
Porter des gants de protection.
Attention ! Arrêtez la machine et débranchez le câble d'alimentation de la machine avant
de l'assembler, de la nettoyer, de la régler et d'effectuer des travaux d'entretien, ainsi que
pour la transporter.
Sens du ruban de scie
Classe de protection II (double isolation)
www.scheppach.com FR | 37