Connection Terminals; Mechanical Mounting - ASO Safety Solutions ELMON relay 32-242 Manuel D'utilisation

ELMON relay 32-242
Safety Relay
If there is no fault alarm, the operati ng state is shown via the LED Power (on). When signalling a fault alarm
the number of pulses emitt ed indicates the nature of the fault:
Pulse Fault alarm
1 Supply voltage outside the available range
3 Output control Stop Channel 1 faulty
4 Output control Stop Channel 2 faulty
5 Data transfer between microcontrollers faulty
6 Error in testi ng signal input (Channel 1 / Channel 2)
6.2 Connecti on terminals
Pin 1 2 (Not allocated)
Pin 3 11 Signal input Channel 1
Pin 3 10 Signal input Channel 2
Pin 4 5 Relay output to Channel 1 control
Pin 6 7 Relay output to Channel 2 control
Pin 8 9 Supply voltage 24 V AC/DC
7. Mechanical mounti ng
The switching unit must be mounted correctly:
• In a dust-protected and moisture protected switch cabinet or casing.
• For use in an environment with contaminati on level 2.
• With a protecti on type of at least IP54.
• On a 35 mm DIN support rail according to EN 50 022 .
The switching unit must not be installed in the immediate vicinity of an intense heat source.
The switching unit can be installed in any positi on.
The unit must not be operated in areas with major temperature changes.
6
5
7
8 4
9
3
10 2
11 1
17