REX Sport RX-600 G Manuel De L'utilisateur page 30

Assembly
STEP 4
GB-30
REX_Trainer_RX600G_13.indd GB-30 REX_Trainer_RX600G_13.indd GB-30
WARNING
1. Release the four screws (50) from the retainer of the
seat clamp (10).
2. Mount the rear handgrips (8) to the retainer of the
seat clamp (10) using the screws released in Step 1.
During the assembly, make certain that both hand-
grips are installed on the respectively correct side.
For better identifi cation, the handgrips have been
marked with an „L" for left and an „R" for right (see
Fig. 10).
3. Mount both pedals (44 L&R) to the crossbar (9 L&R)
of the device.
During the assembly, make sure that both pedals are
installed on the respectively correct side, otherwise
they could break out. The right pedal is screwed in
clockwise and the left pedal is screwed in anti-
clockwise. For better identifi cation, the pedals have
been marked with an „L" for left and an „R" for
right. Tighten both pedals fi rmly (see Fig. 11)
4. Set up the machine at the designated location.
5. Use the rear left and right height regulation to align
the device so that it stands securely and fi rmly.
6. Before every workout, pull the seat adjuster (33) up
and adjust the seat distance that best suits you (see
Fig. 12). The machine is ready to operate.
Assembly
21.05.13 10:46 21.05.13 10:46