Assembly - REX Sport RX-600 G Manuel De L'utilisateur

Assembly

STEP 2
GB-28
REX_Trainer_RX600G_13.indd GB-28 REX_Trainer_RX600G_13.indd GB-28
WARNING
1. Release the four screws (55) and washers (77) from
the front handgrips (101).
2. Connect the pulse sensor cables (17+99) on both
sides.
3. Mount the front handgrips (101) to the handlebar
support tube using the screws released in Step 1.
During the assembly, make certain that both hand-
grips are installed on the respectively correct side.
For better identifi cation, the handgrips have been
marked with an „L" for left and an „R" for right (see
Fig. 4).
4. Release the four screws (94) at the back of the dis-
play (14).
5. Connect the battery cable (112) to the cable from
the battery opening of the display (14).
6. Carefully insert the cable into the display until the
batteries have contact and close the opening with
the battery cover (113).
7. Connect the upper computer cable (15) and both
pulse sensor cables (99) to the cables on the back of
the display (14).
8. Carefully insert the cables into the handlebar sup-
port tube (4) until they touch the display.
9. Screw the display together with the screws released
in Step 4 (see Fig. 5).
10. Release both screws (76) from the seat adjuster
(33).
11. Push the seat adjuster (33) into the retainer of the
seat clamp (10).
12. Screw the seat adjuster (33) together with the
screws released in Step 10 (see Fig. 6).
Assembly
21.05.13 10:46 21.05.13 10:46