Ryobi RBC42FSBO Manuel D'utilisation page 34

of the line spool.
4. Replace the string head cover, aligning latches with
openings in the grass trimmer head. Press cover and
grass trimmer head together until both latches snap
into openings securely.
5. Install the cutting line. Refer to "String replacement"
later in the manual for additional information.
Installing the cutting attachment guard
See fi gure 9.
1. Attach the cutting attachment guard to the mounting
bracket and align the screw holes on the cutting
attachment guard to the screws on the mounting
bracket.
2. Tighten screws securely.
WARNING
When using the ReelEasy™ grass trimmer head and
Tri-Arc™ blade, the cutting attachment guard must be
attached to the mounting bracket.
WARNING
When using the saw blade, the saw blade guard must
be attached to the mounting bracket.
OPERATION
FUEL AND REFUELING
Handling the fuel safely
■ Always handle fuel with care. It is highly flammable.
■ Always refuel outdoors where there are no sparks and
flames. Do not inhale fuel vapour. Do not smoke.
■ Do not let petrol or lubricant come in contact with your
skin.
■ Keep petrol and lubricant away from the eyes. If petrol
or lubricant comes in contact with the eyes, wash
them immediately with clean water. If irritation is still
present, see a doctor immediately.
■ Clean up spilled petrol immediately.
MIXING THE FUEL
■ This product is powered by a 2-stroke engine and
requires pre-mixing petrol and 2-stroke lubricant.
Premix unleaded petrol and 2-stroke engine lubricant
in a clean container approved for petrol.
■ This engine is certifi ed to operate on unleaded petrol
intended for motor vehicle use with an octane rating of
91([R+M]/2) or higher.
■ Do not use any type of pre-mixed petrol/lubricant from
English (Original instructions)
■ Use synthetic 2-stroke lubricant only. Do not use
■ Mix 2.5% synthetic 2-stroke lubricant into the petrol.
■ Mix the fuel thoroughly and also each time before
■ Mix in small quantities. Do not mix quantities larger
FILLING THE TANK
■ Clean
■ Loosen fuel cap slowly to release pressure and to
■ Carefully pour fuel mixture into the tank. Avoid spillage.
■ Prior to replacing the fuel cap, clean and inspect the
■ Immediately replace the fuel cap and hand-tighten.
Always shut off engine before fuelling. Never add fuel
to the product when it is running or when the engine is
hot. Move at least 9 m (30 ft) from refuelling site before
starting the engine. Do not smoke.
STARTING AND STOPPING
Never start or run the engine inside a closed or poorly
ventilated area; breathing exhaust fumes can kill.
23
fuel service stations.
automotive lubricant or 2-cycle outboard lubricant.
This is a 40:1 ratio.
refueling.
than usable in a 30-day period. A synthetic 2-stroke
lubricant containing a fuel stabiliser is recommended.
1 Litre + 25 ml
2 Litres + 50 ml
3 Litres + 75 ml
4 Litres + 100 ml =
5 Litres + 125 ml =
surface around
contamination.
keep fuel from escaping around the cap.
gasket.
Wipe up any fuel spillage. Move 9 m away from the
refueling site before starting the engine.
NOTE: It is normal for smoke to be emitted from a new
engine during and after first use.
WARNING
Choke position A
Choke position B
WARNING
=
=
= 40:1
fuel cap to prevent