Starting Up The Machine (Scrubbing/Drying) - Nilfisk Advance SC250 Instructions D'utilisation

ENGLISH

STARTING UP THE MACHINE (SCRUBBING/DRYING)

1. Press the lever (8) and turn the handlebar (1), adjusting its position and inclination as preferred.
2. Ensure that the park pedal (10) is lowered, then push the machine over to the area to be cleaned.
3. Lift the park pedal (10) to bring the brush/squeegee unit in contact with the floor.
4. Press the switch (2) to start the machine.
5. Press the solution push-button (3) according to the type of cleaning to be performed:
• 1 LED on - for normal dirt
• 2 LEDs on - for heavy dirt
6. Manoeuvre the machine with your hands on the grip handles (6) and start scrubbing/drying the floor.
NOTE
The grip handles (6) have sensors which allow the brush and solution to be started up only when the operator has their
hands on at least one of the grip handles.
7. If necessary, deactivate the vacuum system by pressing the push-button (4, LED off), then press it again to reactivate it (LED
on).
8. To collect medium-large debris, lift the front squeegee by pressing the lever (7).
To keep the front squeegee lifted, press the lever (7) and lock it with the push-button (9A).
9. If necessary, in order to use the handlebar allowing it to tilt, press the lever (8) and lock it with the button (9B).
NOTE
To unblock the function of the push-buttons (9A, 9B) and return to the lowered front squeegee and fixed handlebar,
briefly press the squeegee lever (7) or the handlebar inclination lever (8).
10. For floors with particularly tough dirt, the pressure of the brush on the floor can be increased by turning the knob (19) to the
left. Turn the knob (19) to the right to decrease the pressure.
NOTE
For correct scrubbing/drying of floors at the sides of the walls, Advance suggests to go near the walls with the right side
of the machine as shown in figure 3.
NOTE
If applicable, to better dry the grout lines between the tiles, move in a diagonal direction with respect to the floor layout,
as shown in figure 4.
CAUTION!
In the event of a brush motor overload, the battery symbol LEDs (5) will flash simultaneously.
If the overload persists, the brush stops.
To start scrubbing again after a brush stop due to overload, turn off and then on the machine with the push-
button (2).
CAUTION!
To avoid damaging the floor surface, turn off the brush rotation by releasing the grip handles (6) when the
machine is not operating.
CAUTION!
Use always the machine with solution; avoid using the machine dry without solution for long period of time.
10
INSTRUCTIONS FOR USE
Figure 3
SC250 - 9100001616
P100934
Figure 4
P100935
07/2016