After Using The Machine; Machine Long Inactivity; Removing The Battery; Maintenance - Nilfisk Advance SC250 Instructions D'utilisation

ENGLISH

AFTER USING THE MACHINE

After working, before leaving the machine:
1. Stop and turn off the machine, then lift the brush/squeegee
unit using the pedal (10).
2. Empty the tanks (13).
3. Park the machine as shown in the figure 7; for lowering the
handlebar (1) press the lever (8).
4. Remove the brush and squeegees as described in the
specific paragraphs of the Maintenance chapter.
5. Charge the battery and carry out the daily maintenance
(see the Maintenance chapter).
6. Store the machine in a clean and dry place.

MACHINE LONG INACTIVITY

If the machine is not going to be used for more than 30 days,
proceed as follows:
1. Perform the procedures shown in After using the machine
paragraph.
2. Remove the battery (27) from the machine as shown in the
following paragraph.

REMOVING THE BATTERY

To remove the battery from the machine:
1. Remove the cover (26).
2. Use the battery handle (27) to lift it upwards, then remove
the battery from the machine.

MAINTENANCE

The lifespan of the machine and its maximum operating safety are ensured by correct and regular maintenance.
The following chart provides the scheduled maintenance. The intervals shown may vary according to particular working conditions.
WARNING!
The procedures must be performed with the machine off and the battery disconnected.
Moreover, carefully read the instructions in the Safety chapter.
All scheduled or extraordinary maintenance procedures must be performed by qualified personnel, or by an authorized Service
Center.
This Manual describes only the simplest and most common maintenance procedures.
For other maintenance procedures shown in the Scheduled Maintenance Table, refer to the Service Manual that can be consulted
at any Service Center.

SCHEDULED MAINTENANCE TABLE

Battery charging

Squeegee bar cleaning

Brush Cleaning
Cleaning of the brush compartment and the debris collection tray
Recovery tank and solution tank rinsing
Cleaning of intake duct
Cleaning of the solution dispensers
Squeegee blades check
Detergent filter cleaning
Cleaning of the air filter and gaskets
Squeegee bar replacement
12
INSTRUCTIONS FOR USE
Procedure
SC250 - 9100001616
Figure 7
Daily, after using the
machine
Weekly Every six months
P100938
07/2016