Nilfisk Advance SC250 Instructions D'utilisation page 7

WARNING!
– Do not use the machine on slopes.
– Do not use the machine on slopes with a gradient exceeding the specifications.
– Do not use the machine in particularly dusty areas.
– Use the machine only where a proper lighting is provided.
– While using this machine, take care not to cause damage to people or objects.
– Do not bump into shelves or scaffoldings, especially where there is a risk of falling objects.
– The machine operating temperature must be between +32 °F and 104 °F (0 °C and +40 °C).
– The machine storage temperature must be between +32 °F and 104 °F (0 °C and +40 °C).
– The humidity must be between 30 % and 95 %.
– When using floor cleaning detergents, follow the instructions on the labels of the detergent bottles.
– To handle floor cleaning detergents, wear suitable gloves and protections.
– Do not use the machine as a means of transport.
– Do not allow the brush to operate while the machine is stationary to avoid damaging the floor.
– In case of fire, use a powder fire extinguisher, not a water one.
– Do not tamper with the machine safety guards and follow the ordinary maintenance instructions
scrupulously.
– Do not allow any object to enter into the openings. Do not use the machine if the openings are clogged.
Always keep the openings free from dust, hairs and any other foreign material which could reduce the air
flow.
– Do not remove or modify the plates affixed to the machine.
– This machine cannot be used on roads or public streets.
– Pay attention during machine transportation when temperature is below freezing point. The water in the
recovery tank or in the hoses could freeze and seriously damage the machine.
– Use only the brushes supplied with the machine or those specified in the Instructions for Use Manual. Using
other brushes could reduce safety.
– Using other brushes could reduce safety.
– In case of machine malfunctions, ensure that these are not due to lack of maintenance. If necessary, request
assistance from the authorized personnel or from an authorized Service Center.
– If parts must be replaced, require ORIGINAL spare parts from an Authorized Dealer or Retailer.
– To ensure machine proper and safe operation, the scheduled maintenance shown in the relevant chapter of
this Manual, must be performed by the authorized personnel or by an authorized Service Center.
– Do not wash the machine with direct or pressurized water jets, or with corrosive substances.
– The machine must be disposed of properly, because of the presence of toxic-harmful materials (batteries,
etc.), which are subject to standards that require disposal in special centers (see Scrapping chapter).
07/2016
INSTRUCTIONS FOR USE
9100001616 - SC250
ENGLISH
5