Starting Up The Machine (Scrubbing/Drying) - Nilfisk SC401 Instructions D'utilisation

Masquer les pouces Voir aussi pour SC401:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

ENGLISH
(For machines without Detergent System)
3.
Fill the tank (21) with a solution suitable for the work to be performed.
Do not fill the tank completely, leave a few inches from the edge. Use the level hose (13) as reference.
Always follow the dilution instructions on the label of the chemical product used to prepare the solution.
The solution temperature must not exceed 40 °C.
(For machines with Detergent System)
4.
Fill the tank (21) with clean water.
Do not fill the tank completely, leave a few inches from the edge. Use the level hose (13) as reference.
The water temperature must not exceed 40 °C.
Detergent tank filling (For machines with Detergent System)
5.
Lift the cover (34) and check that the recovery tank (33) is empty; if not, empty it using the drain hose (12).
6.
Close the cover (34).
7.
Grasp the handle (16) and carefully lift the tank (33).
8.
Fill the tank (17) with a detergent suitable for the work to be performed (highly concentrated detergent).
Do not fill the detergent tank completely, leave a few inches from the edge.
CAUTION!
Use only low-foam and non-flammable detergents, intended for automatic scrubber applications.

STARTING UP THE MACHINE (SCRUBBING/DRYING)

1.
Prepare the machine as shown in the previous paragraph.
2.
(If equipped) Turn the ignition key (41) to "I".
Press the main push-button (42) to start the machine.
NOTE
First flashes on the battery symbol (45) indicate the type of batteries installed (see paragraph "Battery type setting").
NOTE
Check the battery charge level.
6 LEDs on the battery symbol (45) indicate the battery charge level.
When there is only one LED turned on and flashing, it is advisable to charge the batteries, because the residual
autonomy will last for a few minutes, depending on battery characteristics and work to be performed (for battery charging
procedure see the Maintenance chapter).
CAUTION!
Do not use the machine with discharged batteries, to avoid damaging the batteries and reducing the battery life.
3.
Drive the machine to the working place:
(Only for no drive versions) push the machine with the hands on the handlebar (1).
(Only for drive versions) start the machine with at least one hand on the presence sensors (46) on the handlebar to move
forward. The maximum forward speed can be adjusted with the adjuster (47). For reverse gear, press the push-button (48)
and place the hands on the sensors (45).
NOTE
When the machine is turned on and the hands are on the presence sensors, if the machine is equipped with hour counter
(49), it is possible to read the total number of working hours performed.
4.
Lower the squeegee (29) with the pedal (7).
5.
Lower the brush deck by pressing the pedal (10-B).
6.
Press the main push-button (42, LED on) to start the machine scrubbing/drying functions.
7.
Manoeuvre the machine by placing your hands on the sensors (46) on the handlebar, and start scrubbing/drying the floor.
NOTE
The presence sensors (46) on the handlebar allow the brush and solution to be started up (on drive versions) only when
the operator has the hands on at least one of the knobs.
14
INSTRUCTIONS FOR USE
SC401, SCRUBTEC 344 - 9100002291
09/2017

Hide quick links:

Publicité

Table des Matières
loading

Table des Matières