Assa Abloy OneSystem 519N Notice De Montage page 56

Fastening the motorised
multi-point lock
Fasten the appropriate
striking plate
Fasten the locking
cylinder with the
cylinder fixing screw
Check for complete
functionality
Fig. 6 :
No transverse shear
stress on the bolt after
installation
EN
56
Installing the motorised multi-point lock 519N
1 Adjust the closing direction of the control latch
("Adjusting the closing direction of the latch", page 57).
2 Fasten the motorised multi-point lock 519N in the lock pocket.
3 Fasten the lock fittings.
4 Check the motorised multi-point lock 519N for ease of movement.
 Once the striking plate has been mounted, the motorised multi-point lock 519N is ready for use.
Mounting the striking plate
1 Finish the striking plate pocket and all holes or finish a customer-provided striking plate ("Production
of customer-provided striking plates", page 64).
2 Clean the striking plate pocket and all holes by blowing them out or vacuuming.
3 Screw in the appropriate locking plate for the motorised multi-point lock 519N to be screwed in.
4 Check the motorised multi-point lock 519N for ease of movement.
 The motorised multi-point lock 519N is ready for operation.
Installing fittings and locking cylinders
1 Install the fittings.
2 Insert the locking cylinder and ensure that the locking cylinder nose is in the centre position (Fig. 14).
3 Fix the locking cylinder into place with the fixing screw.
 The motorised multi-point lock 519N is completely installed.
Testing the motorised multi-point lock 519N
1 Test all functions of the motorised security lock 519N.
2 Check whether the control latch and auxiliary latch bolt of the lock are pushed back by the same
impact edge.
3 Check whether all bolts can freely extend and retract without transverse shear stress after installation
(Fig. 6).
 The multi-point lock 519N is completely installed and has been tested for functionality.
Striking plate
F
= 0
Q
N
min. 2
F
= 0
Q
N
Face plate
Installation