Fig. 7 :
Lock type according to
DIN left hand and
DIN right hand
Fig. 8 :
Rotating the control latch
Installation
Adjusting the closing direction of the latch
The closing direction of the lock can be switched for use in DIN left hand and DIN right hand doors (Fig. 7).
For this purpose, the control latch must be rotated before the lock is installed in the door.
DIN left hand
1.
2.
5.
6.
6.
Triggering self- locking
1
3.
2
3
The deadbolt is eliminated and the screw for
Rotating the control latch
4.
4
3x
1,5 mm
5
6
7.
7
The latch was installed matching the closing
DIN right hand
Press and hold the latch bolt (Fig. 8).
Press the control latch.
Release the latch bolt while pressing the
control latch.
the control latch can be reached.
Unscrew the locking screw with an Allen
wrench.
· Do not unscrew the locking screw entirely.
· Leave the Allen wrench in the bolt head.
Pull out the latch.
Turn the latch 180 degrees and re-insert it.
Fix the latch with the locking screw (torque
0.5 Nm).
direction of the door.
EN
49