Guided Magnetic Encoder System; Connection Cable With Drive-Cliq/S115 Plug; Connection Cable With S284/S115 Plug - Balluff DRIVE-CLiQ Notice D'utilisation

BML SGA-AEZ1-LZZZ- _ _ _1- _ _ _ _
Absolute magnetic encoder system
8
Accessories (continued)
8.5

Guided magnetic encoder system

Sensor guide consisting of a BML-R01-M_ _ _ aluminum
rail to hold the magnetic tape and a BAM GM-ML-01-C04
(BAM021H) slide with gliders to guide the sensor head.
Fig. 8-3: Sensor with sensor guide
8.6

Connection cable with DRIVE-CLiQ/S115 plug

For use with BML SGA-AEZ1-LZZZ-ZU11-S115. Cable per
SIEMENS-6FX8002-2DC30 standard.
~44
Fig. 8-4: Connection cable with DRIVE-CLiQ/S115 plug, example
Permissible bending radius
Fixed routing 5 × outer diameter
Moved 10 × outer diameter
Feature Drag chain compatible
(10 mil. cycles)
Cable coating PUR
Type
BCC M418-Z035-8G-745-PS56NC-050 BCC0L3W
BCC M418-Z035-8G-745-PS56NC-100 BCC0L3Y
Tab. 8-2: Cable types
www.balluff.com
L 47
Order Length
code (L) [m]
5
10
8.7

Connection cable with S284/S115 plug

For sensor head BML SGA-AEZ1-LZZZ-TU11-S284 an
additional connection cable is required which converts the
12-pin M12 connection into a standard 8-pin M12
connection and enables the temperature sensor to be
connected.
This cable must itself be specified and produced according
to the following:
– Use suitable shielding.
– Use suitable cable with wires twisted according to the
specification.
– Use twisted wires for the temperature sensor (+Temp/–
Temp).
– Keep cable (L1) as short as possible.
– Keep cable for the temperature sensor (L2) as short as
possible.
L1
Female
L2
Fig. 8-5: Connection cable S284/S115, example
Connector
english 23