Safety; Intended Use; General Safety Notes For The Magnetic Encoder System; Explanation Of The Warnings - Balluff DRIVE-CLiQ Notice D'utilisation

BML SGA-AEZ1-LZZZ- _ _ _1- _ _ _ _
Absolute magnetic encoder system
2

Safety

2.1

Intended use

The BML magnetic encoder system is intended for
communication with a machine controller (e.g. PLC). It is
intended to be installed into a machine or system and
used in the industrial sector. Flawless function in
accordance with the specifications in the technical data is
ensured only when using original Balluff accessories. Use
of any other components will void the warranty.
Non-approved use is not permitted and will result in the
loss of warranty and liability claims against the
manufacturer.
2.2 General safety notes for the magnetic
encoder system
Installation and startup may only be performed by
qualified personnel with basic electrical knowledge.
Qualified personnel are persons whose technical
training, knowledge and experience as well as knowledge
of the relevant regulations allow them to assess the work
assigned to them, recognize possible hazards and take
appropriate safety measures.
The operator is responsible for ensuring that local safety
regulations are observed.
In particular, the operator must take steps to ensure that a
defect in the magnetic encoder system will not result in
hazards to persons or equipment.
If defects and unresolvable faults occur in the magnetic
encoder system, take it out of service and secure against
unauthorized use.
6 english
2.3

Explanation of the warnings

Always observe the warnings in these instructions and the
measures described to avoid hazards.
The warnings used here contain various signal words and
are structured as follows:
SIGNAL WORD
Type and source of the hazard
Consequences if not complied with
► Measures to avoid hazards
The individual signal words mean:
NOTICE
Identifies a danger that could damage or destroy the
product.
DANGER
The general warning symbol in conjunction with the signal
word DANGER identifies a hazard which, if not avoided,
will certainly result in death or serious injury.
2.4

Disposal

This product falls under the current EU
Directive for WEEE, waste of electrical and
electronic equipment for protecting you and
the environment from possible hazards and
responsible handling of natural resources.
Dispose of the product properly and not as part of the
normal waste stream. Observe the regulations of the
respective country. Information can be obtained from the
national authorities. Or return the product to us for
disposal.