Accessories; Magnetic Tape; Cover Strip; Installation Aid Bam To-Ml-006-S1G (Order Code Bam0256) - Balluff DRIVE-CLiQ Notice D'utilisation

BML SGA-AEZ1-LZZZ- _ _ _1- _ _ _ _
Absolute magnetic encoder system
8

Accessories

Accessories are not included in the scope of delivery and
must be ordered separately.
8.1

Magnetic tape

Measuring range = length – 8 cm
Ballu JJWW ._ _DE Abs Code E
Length
(min. 8 cm, max. 4800 cm = 48 m)
Fig. 8-1: Magnetic tape dimensions.
BML M0_-A55-A_-M_ _ _ _-E
Thickness

Cover strip

2 = Thickness 1.55, 0 = without
3 = with
comes with an
(see Section 8.2)
adhesive layer
(with protective
film) for fastening
For a complete technical description and
assembly instructions for magnetic tapes,
please see the magnetic tape user's guide on
the Internet at www.balluff.com.
8.2 Cover strip
To protect the magnetic tape from damage caused by
chips or chemicals, you may cover it using a stainless steel
cover strip. Note that the permissible gap (see Tab. 4-2 on
page 11 and Tab. 4-3 on page 12) between head and
tape is reduced by the thickness of the cover strip with
adhesive layer (0.15 mm).
Before affixing the cover strip, carefully clean the surface of
the magnetic tape (acetone, turpentine, mild plastic
cleaner, no benzine).
22 english
The cover strip can be ordered in 4 defined lengths on a
roll.
Thickness incl. adhesive layer
Width
Length
e E
10+0.2
Tab. 8-1:
1.55±0.1
Length
in cm
8.3
Fig. 8-2:
8.4
The installation accessories consist of screws, insulators,
washers, drill template, clearance gauge and pole pitch
display card.
Order code
BML-A013-T0500 BML001J
BML-A013-T1000 BML001K
BML-A013-T2400 BML001L
BML-A013-T4800 BML001M
Cover strip data
For a complete technical description and
assembly instructions for cover strips, please see
the magnetic tape user's guide on the Internet at
www.balluff.com.
Installation aid BAM TO-ML-006-S1G
(order code BAM0256)
56.5
32
25
4.2
75
3.5
Installation aid
Mounting accessories BAM TO-ML-014-01
(order code BAM02YC)
Approx. 0.15 mm
10 mm
5 m
10 m
24 m
48 m