Distances, Angles, Distances, Tolerances And Measuring Accuracy - Arch-Shaped Application; Measuring Length - Linear Application - Balluff DRIVE-CLiQ Notice D'utilisation

BML SGA-AEZ1-LZZZ- _ _ _1- _ _ _ _
Absolute magnetic encoder system
4
Installation and connection (continued)
4.3.4 Distances, angles, distances, tolerances and
measuring accuracy – arch-shaped
application (< 360°)
Fig. 4-7: Tolerances for applications with arch-shaped magnetic
tape
Z
(air gap sensor/magnetic tape)
Z
(air gap between sensor/magnetic
tape with cover strip)
Y (lateral offset)
X (tangential offset)
Pitch
Yaw
Roll
Tab. 4-3: Function ranges, angles, distances, and tolerances
4.3.5 Measuring length – linear application
The maximum measuring length of the system is 48 m.
For correct function while maintaining the specified system
accuracies, the magnetic tape length must be greater than
the desired measuring length. There needs to be a reserve
at the beginning and end of the measuring range.
L1
Fig. 4-8: Measurement length, overlap ranges of sensor head to
magnetic tape (longitudinal variant): L1 = overlap range 1,
L2 = overlap range 2
Range Value
Overlap range 1 70 mm
Overlap range 2 10 mm
Measuring length Magnetic tape length – 80 mm
Tab. 4-4: Measuring length data
12 english
Z
X
2000 mm
≤ 0.7 mm
0.55 mm
1751DE ABS PRC E
–Pitch
+Pitch
Z
Diameter
1000 mm
≤ 0.6 mm
0.45 mm
±0.5 mm
34.6 mm ±0.5 mm
±0.5°
±1°
±0.5°
Measuring length
Tangential point
400 mm
≤ 0.2 mm
–
L2