Publicité
Les langues disponibles
Les langues disponibles
Do not dispose of waste batteries,
waste electrical and electronic
equipment as unsorted municipal
waste. Waste batteries and waste
electrical and electronic equipment
must be collected separately. Waste
batteries, waste accumulators, and
light sources have to be removed from
the equipment. Check with your local
authority or retailer for recycling advice
and collection point. According to local
regulations, retailers may have an
obligation to take back waste batteries
and waste electrical and electronic
equipment free of charge. Your
contribution to the reuse and recycling
of waste batteries and waste electrical
and electronic equipment helps to
reduce the demand of raw materials.
Waste batteries, in particular
containing lithium, and waste electrical
and electronic equipment contain
valuable and recyclable materials,
which can adversely impact the
environment and the human health if
not disposed of in an environmentally
compatible manner. Delete personal
data from waste equipment, if any.
SYMBOLS IN THIS MANUAL
Note
Warning
GETTING STARTED
See page 196-197.
1. Wear Personal Protective Equipment (PPE).
Wear full eye protection, ear protection, non-slip heavy-
duty gloves, substantial footwear, and protective clothing
at all times while operating the product. Do not operate
the product when barefoot or wearing open sandals.
2. Remove the guide bar cover.
3. Adjust the chain tension. Turn the guide bar locking knob
counterclockwise to unlock.
To increase the chain tension, turn the chain tension
knob clockwise.
To reduce the chain tension, turn the chain tension knob
counterclockwise.
NOTE: The chain tension is correct when the gap
between the cutter in the chain and the bar is between 2
and 3 mm. Pull the chain in the middle of the lower side
of the bar downwards (away from the bar), and measure
the distance between the bar and the chain cutters.
NOTE: The temperature of the chain increases during
normal operation, causing the chain to stretch. Check
the chain tension frequently and adjust as required. A
chain that is tensioned while warm may be too tight upon
cooling. Make sure that the chain tension is correctly
adjusted as specified in these instructions.
4. Rotate the guide bar locking knob clockwise to lock.
5. Install the battery pack.
Insert the battery pack into the product. Make sure that
the latch of the battery pack clicks in place and that the
battery pack is fully seated and securely attached before
beginning operation.
6. Start the product.
Press the trigger release and squeeze the switch trigger.
NOTE: To stop the product, release the switch trigger.
9
Original Instructions
EN
FR
DE
ES
IT
NL
PT
DA
SV
FI
NO
RU
PL
CS
HU
RO
LV
LT
ET
HR
SL
SK
BG
UK
TR
EL
Publicité
