Ryobi RHT400 Manuel D'utilisation page 16

GB
F D E I
SERVICE
Servicing requires extreme care and knowledge
and should be performed only by a qualified service
technician. For service we suggest you return the
product to your nearest AUTHORISED SERVICE
CENTRE for repair. When servicing, use only identical
replacement parts.
WARNING
Observe all normal safety precautions related to
avoiding electrical shock.
WARNING
To avoid serious personal injury, do not attempt
to use this product until you read thoroughly
and understand completely the operator ʼs
manual. Save this operatorʼs manual and review
frequently for continuing safe operation and
instructing others who may use this product.
WARNING
The operation of any power tool can result in
foreign objects being thrown into your eyes,
which can result in severe eye damage. Before
beginning power tool operation, always wear
safety goggles or safety glasses with side
shields and a full face shield when needed.
We recommend Wide Vision Safety Mask for use
over eyeglasses or standard safety glasses with
side shields. Always use eye protection.
SAVE THESE INSTRUCTIONS.
SPECIFICATION
PRODUCT SPECIFICATIONS
Voltage :............................................................220~240 V
Power :.....................................................................400 W
Cutting Capacity :....................................................18 mm
Blade Length :.......................................................450 mm
Blade Speed :...................................................1700 min
Braking Time :..............................................................<1s
Weight :....................................................................3.0 kg
Sound Pressure Level :........................................91 dB(A)
Sound Power Level :...........................................102dB(A)
Vibration :............................................................2.51 m/s²
DESCRIPTION
Fig.1
1. Blades
All manuals and user guides at all-guides.com
P NL S DK N FIN GR HU CZ RU RO PL SLO HR TR EST LT
English
2. Safety Guard
3. Front Handle grip with on/off switch
4. Rear handle with on/off switch
5. Pull Relief for cord
6. Live tool indicator
7. Scabbard
Fig.7
8. CUTTER BLADE
9. GUARD
OPERATION
POWER CONNECTION
The mains voltage must conform to the specifications
n
on the rating plate.
Connect the tool plug to an approved extension lead
n
(if required) and protect the plug connection with the
pull-relief (5) (Fig. 2).
Once plugged to electric supply, the live tool indicator
n
(9) shows a blue light, which means this tool is ready
for use.
RANGE OF USE
Cutting and trimming of hedges, bushes and ornamental
shrubs in the domestic sector only. All other uses are
expressly excluded.
SWITCHING ON AND OFF
This tool is equipped with a two-hands safety switching
system. This system prevents starting the tool
inadvertently and will only allow operation while holding
the tool with both hands.
To switch on: press the bow grip on/off switch (3) and
n
the on/off switch at rear handle (4) with both hands at
the same time. SEE FIGURE 3
To switch off : release on/off switch (3) and /or rear
n
handle switch(4)
The electric brake will stop the blade within one
n
-1
second.
The sparking (flashing) resulting in the area of the vent
slits / top of the main enclosure is normal and will not
damage the tool.
When you stop your equipment, be sure that the
n
cutting system comes to complete stop before
proceeding further.
CUTTING HEDGES
Clean up the cutting area before starting. Take away
n
13
LV
OPERATION
SK BG