Publicité
General Safety Information
The following general safety precautions must be observed during all phases of
operation, service and repair of this instrument. Failure to comply with these
precautions or with specific warnings elsewhere in this manual violates safety
standards of design, manufacturer and intended use of the instrument. Keysight
Technologies assumes no liability for the customer's failure to comply with these
requirements.
– Observe all markings on the equipment before connecting any wiring to
WARNING
–
– Do not measure more than rated voltage (as marked on the equipment).
– Inspect the test probe for damaged insulation or expose metal and check
– Do not operate the equipment in the presence of flammable gases or
– Do not use the equipment if it does not operate properly. Have the
6
the equipment.
DO NOT connect the test probe to MAINS.
Installation CAT II (when used as stand-alone)
Measurement category: None
MAINS CIRCUITS);
Maximum Working Voltage: 30 Vrms or 42 Vpeak or 60 Vdc
for continuity. Do not use test probe if found damaged.
fumes, vapor, or wet environments.
equipment inspected by qualified service personal. If necessary, return
the equipment to Keysight for service and repair to ensure that safety
features are maintained.
30 Vrms max (NOT for measurements on
–
Keysight U2701A/U2702A User's Guide
Publicité
