Publicité
2
Scope Features and Functions
Automatic Measurement Procedures
Automatic measurements can be used on any channel source or any running math
function. Cursors are turned on to focus on the most recently selected
measurement.
1 Select the markers for your measurement.
2 Select either Channel 1 or Channel 2 according to the waveform you want to
3 Select the desired measurement from the Measurements panel. The
To select single or multiple measurements,
1 Drag and drop a measurement
2 Drag and drop multiple measurements
3 Double-click on a measurement
4 Select the measurement and press Enter
58
Markers enable you to expand the time base around the start and stop events
of the time interval to be measured, thus achieving more time resolution than
the automatic measurements.
measure. Math function and FFT channel can be selected if they are enabled.
Measurements Results panel is displayed at bottom of the graph.
Click on the desired measurement icon, while holding the selected
measurement, drag it over to the Measurements Results panel. Drop the
selection on the panel.
On the Measurements panel, hold down the mouse button, drag and select
multiple measurements. Drag all the selected measurements and drop the
selections on the Measurement Results panel.
Go to your desired measurement and double click on the icon.
Click on the desired measurement icon and press Enter. To select more than
one measurement, press Ctrl and click on the desired measurements icons
then press Enter.
Keysight U2701A/U2702A User's Guide
Publicité
