Publicité
Probe Attenuation Control
The probe attenuation control changes the attenuation factor for the probe. The
attenuation factor changes the vertical scaling of the oscilloscope so that the
measurement results will reflect the actual voltage levels at the probe tip.
To change the probe attenuation factor for channel 1, click on the
the soft front panel. Click on the
Attenuation from the options list. An option list containing the attenuation factors
in 1X, 10X, 100X will appear, select the desired factor.
Table 2-1
Probe attenuation factors and its corresponding settings.
Probe attenuation factors and correspond ing settings
1:1
10:1
100:1
Volt/Div Control
The Volt/Div control sets the sensitivity of the channel. You can select the channel
sensitivity from the drop-down list.
Keysight U2701A/U2702A User's Guide
channel options button and select
1X
10X
100X
Drop-down list
Scope Features and Functions
2
button on
35
Publicité
