Table des Matières
Publicité
13 Assembly Instructions
13�1 Attaching the scraper to the M 5000/M 5000.18
scraper holder
Carriage bolt
Reinforcing sheet metal
Scraper /
Frankenklinge
CAUTION: beveled side below!
Locking plate
optional
retaining lock nut
Reinforcing sheet metal for Scraper
Mounting devices 2x Coach bolt, 2x retaining lock nut
Locking plate
Place scraper on the
Place reinforcement
scraper holder.
Édition FR 2022/01
Service de conseil téléphonique :
+49(0)92 78-774 33-0
+49(0)92 78-774 33-11
www.vogt-tec.de
Scraper must rest
on the edge
100 - 120mm width
160 - 300 mm width
Insert carriage
plate on top.
screws.
VOGT Hammer Traduction des instructions originales
Scraper holder M 5000 / M 5000.18
902 004
902 005
902 008
902 002
Ensure that the
Tighten retaining
scraper directly
lock nuts by hand
touches the
scraper holder.
YouTube Manual: Mounting Scraper holder
Assembly Instructions
Assembly Instructions
Mounted:
Scraper
Fertig montiert:
Schaber
Frankenklinge
180°
Tighten with defined angle.
New nuts:
180°
Reused nuts:
100°
or tightening torque 52 nm
Sous réserve de modifications
53
Publicité
Table des Matières
