Switching Off - Reely HOTLANDER NEXT GENERATION RTR Notice D'utilisation

4 p
REpARATION
4.4
s
TARTING THE
- Remove lid of battery compartment on the
lower side of the transmitter.
- Insert 8 AA (rechargeable) batteries in the
compartment,
observe the correct polarity!
- Close the lid again
- Place the battery support with the
cables and the plug in the RC-box
again.
- Carefully connect both red plugs.
- Guide the antenna of the receiver
through the antenna guiding tube
- Stick the lower end of the antenna
guiding tube into the recess on the
cover of the RC box.
- Fasten the antenna wire on the
top at the guidance tube, by
wrapping adhesive tape around it
or by placing a rubber cap.
Do not shorten the antenna!
© REELY 01/08
Rc I
NsTALLATION
- Open RC-box on the chassis
and
- remove the battery support
of the RC-box.
- Rremove the receiver
- Unwind the wire of the antenna
- Switch the transmitter on.
The blue LED in the leg of the
transmitter should light up.
If the LED does not light up, check
batteries /rechargeable batteries
and replace them, if necessary.
- Place 4 AA batteries (rechargeable
batteries) in the support.
- Observe correct polarity
and tightness.
- Guide the antenna wire through
the opening in the cover of the RC
box outwards.
- Switch on the receiver with the
switch on the RC-box.
The servos must turn in neutral
position.
NOTE!
Switching on:
1. Transmitter, 2. Receiver

Switching off:

1. Receiver, 2. Transmitter
41