Warning/Alarm Indicators - Panasonic PV-GS400 Mode D'emploi

PV-GS400Eng.book 73 ページ ２００４年６月４日 金曜日 午後３時１７分

Warning/Alarm Indicators

If any one of the following indicators lights up or
flashes, please check the condition of the
Camcorder.
3DEW (DEW DETECT/EJECT TAPE):
Condensation has occurred.
Y (CHECK REC TAB):
The accidental erasure prevention switch on
the inserted Cassette is open (that is, set to
[SAVE]).
You are attempting Audio dubbing or Digital
dubbing on a Tape while setting the
accidental erasure prevention switch to
[SAVE].
Y (TAPE NOT INSERTED):
No Cassette in inserted.
6 (LOW BATTERY):
The Battery is low. Recharge it.
0: The built-in battery is low.
: (NEED HEAD CLEANING):
The video heads are dirty.
2END (TAPE END):
The Tape came to an end during recording.
REMOTE (CHECK REMOTE MODE):
Wrong Remote Controller Mode has been
selected.
-16-
UNPLAYABLE TAPE
(OTHER FORMAT):
You are attempting to play back a tape
section that has been recorded with a
different TV system.
UNABLE TO A.DUB
(LP RECORDED):
Because the original recording was done in
LP Mode, audio dubbing cannot be
performed.
INCOMPATIBLE TAPE:
This cassette is incompatible.
PUSH THE RESET SWITCH:
Irregular mechanism is detected. Use
projection on the Lens Cap to press the
[RESET] Button (
-13-
problem.
CARD FULL:
Card does not have sufficient memory
remaining.
Select Picture Playback Mode and delete
unnecessary files.
NO CARD:
Card is not inserted.
NO DATA:
There are no recorded files on the Card.
UNPLAYABLE CARD:
You are attempting to play back data which
is not compatible with this Camcorder.
Others
CARD ERROR:
COPY INHIBITED:
-83-
CANNOT USE USB
CHANGE MODE:
CANNOT OPERATE:
-18-
-16-
UNABLE TO WRITE
-26-
(MULTI RECORDING):
-83-
UNABLE TO WRITE:
NO TITLE:
UNABLE TO INSERT TITLE:
UNABLE TO WRITE
(WIDE MODE):
FILE LOCKED:
CARD LOCKED:
). This may solve the
DISCONNECT USB CABLE:
PC DOES NOT SUPPORT USB2.0:
CAN NOT USE USB:
The Card is not compatible with this
Camcorder.
Because the media is protected by a copy
guard, images cannot be recorded correctly.
The USB Cable is connected to the
Camcorder in Card Recording Mode.
You are attempting to turn the Camcorder
off while connecting the USB Cable to the
Camcorder.
You are attempting to record pictures on a
Card while connecting the USB Cable to the
Camcorder in Tape Recording/Playback
Mode.
The [PHOTO SHOT] Button is pressed
when you are recording pictures on a Tape
while setting the Digital Effect [MULTI] of
[EFFECT1].
The [PHOTO SHOT] Button is pressed
when you are recording on a Tape and
while inserting a Title.
Titles are not recorded.
You are attempting to perform Title In
Function when RapidFire Consecutive
Photoshot function is set.
You are attempting to record S1 signal
pictures (with aspect ratio 16:9) by pressing
the [PHOTO SHOT] Button.
You are attempting to erase protected files.
The write protection switch on the SD
Memory Card is set to [LOCK].
You are attempting to turn the Mode Dial in
PC Mode while connecting the USB Cable
to the Camcorder.
In the MotionDV STUDIO Mode, your
personal computer does not support USB
2.0 Hi-Speed.
You are attempting to connect the USB
Cable while the DV Cable is connected.
73