Panasonic PV-GS400 Mode D'emploi page 76

PV-GS400Eng.book 76 ページ ２００４年６月４日 金曜日 午後３時１７分
≥When you rotate the Mode Dial or remove the
battery, Quick Start Recording Lamp is turned
off and Quick Start Mode is canceled. However,
if the Camcorder is turned on and the
Tape/Card Recording Mode is set, the Lamp
turns on and Quick Start Mode is restored.
≥If the [QUICK START] Button is pressed and
held for approximately 2 seconds during the
Quick Start Standby Mode, the Lamp will go off
and the Camcorder will be completely turned
off.
≥If the Camcorder is not operated for
approximately 30 minutes when the Quick Start
Recording Lamp lights, the Lamp will go off and
the Camcorder will be completely turned off.
≥In the Automatic White Balance Mode, the color
may be recorded unnaturally at the beginning of
the recording.
≥The zoom magnification differs from when it is in
the Quick Start Standby Mode and when the
recording starts.
ª Self-timer Recording
≥When [BEEP SOUND] on the [INITIAL]
Sub-Menu is set to [ON], the beep sound will be
emitted along with Recording Lamp flashing in
the Self-timer Standby Mode.
≥By operating the [OFF/ON] Switch, Mode Dial or
Recording Start/Stop Button, the Self-timer
Standby Mode is cancelled.
≥In the Card Recording Mode, the
[PHOTO SHOT] Button does not work even if it
is pressed halfway. However, the subject is
focused in the Focus Area.
ª Zoom In/Out Functions
≥When you are zooming in on a faraway subject,
a sharper focus is achieved if the recording
subject is 4 feet (1.2 meters) or further from the
Camcorder.
≥When the MagicPix Functions are activated or
the Shutter speed is set to 1/15 or lower, the
zoom operation with the Multi Manual Ring is
disabled.
ª Tele-Macro Function
≥The Tele-Macro Function cannot be started
during recording.
≥When the [D.ZOOM] is set to [30k] or [700k],
the Tele-Macro Function with a magnification
greater than 12k is available.
≥If a sharper focus cannot be achieved, adjust
the focus manually.
In the following cases, the Tele-Macro
Function is cancelled.
≥The zoom magnification becomes lower than
12k.
≥Setting the [OFF/ON] Switch to [OFF].
76
Others
ª Zoom Microphone Function
≥The Zoom Microphone Function may not work
effectively if the surrounding noise is too loud.
≥Does not work with an external microphone.
ª Digital Zoom Function
≥As the magnification of digital zoom increases,
the quality of image may deteriorate.
≥White balance cannot be set in the digital zoom
range.
ª Image Stabilizer Function
≥When you press the [PHOTO SHOT] Button
halfway in the Card Recording Mode, the Image
Stabilizer Function works more effective.
([ EIS] Indication appears.)
MEGA
≥When a tripod is used, it is recommended that
you turn the Image Stabilizer off.
≥Within the digital zoom range, or when
recording with a conversion lens (not supplied)
attached, the Image Stabilizer Function may not
work effectively.
ª Backlight Compensation Function
≥When setting the Iris manually, the Backlight
Compensation Function does not work.
≥By operating the [OFF/ON] Switch, the
Backlight Compensation Function is cancelled.
ª MagicPix Functions
≥In a bright place, such as outdoors, the
recorded picture may become whitish.
≥In a dark place, the recorded picture is
presented in a time-lapse-like manner.
≥Adjust the Focus manually.
≥The Progressive Photoshot Function is
automatically turned off.
≥In the Card Recording Mode, using the
MagicPix Functions is not possible.
≥When the [PICTURE SIZE] is set to [1280k960]
in the Tape Recording Mode, the Photoshot
recording is disabled.
≥When using the MagicPix Functions, you cannot
use the Built-in Flash.
≥The shutter speed cannot be adjusted.
≥The Program AE or Digital Effect Modes in
[EFFECT1] cannot be set.
≥When recording with the MagicPix Functions, it
is recommended that you use a tripod.
≥The MagicPix Functions make the signal
charging time of CCD longer up to 16 times
longer than usual, so that the dark scenes that
are invisible to the naked eyes can be recorded
brightly. For this reason, bright dots may be
seen, but this is not a malfunction.
≥The White Balance setting, the Soft Skin
Function and the Backlight Compensation
Function cannot be changed.