HP Photosmart C4340 All-in-One Série Guide D'utilisation page 58

1 Telephone wall jack
2 Use the phone cord supplied in the box with the product
2. After you have connected the phone cord to the port labeled 1-LINE, run the fax test again
to make sure it passes and the product is ready for faxing.
3. Try to send or receive a test fax.
The "Using Correct Type of Phone Cord with Fax" test failed
Solution
• Make sure you used the phone cord supplied in the box with the product to connect to the
telephone wall jack. One end of the phone cord should be connected to the port labeled 1-
LINE on the back of the product and the other end to your telephone wall jack, as shown
below.
1 Telephone wall jack
2 Phone cord supplied in the box with the product
• Check the connection between the telephone wall jack and the product to make sure the
phone cord is secure.
Fax setup troubleshooting 55