Beem ODESSA Mode D'emploi page 26

EN
The heating control lamp (8) lights up as soon as the heating element of the device starts
heating the water. The heating control lamp lights up at intervals when the water is boiling
at intervals.
Removing / Attaching the Lid
1. Hold the lid (15) at the lid handles (4), turn slightly counterclockwise and pull it up-
wards (Illustration A1).
If the device has been in operation, use potholders or similar gloves as the lid might
be hot. Always allow the device to cool down before using it again.
2. To close the lid, place it on the water reservoir (6). Make sure that the recesses on the
lid rest correctly in the locking lugs of the water reservoir. Turn the lid slightly clockwise
until it stops (Illustration A2).
Filling the Water Reservoir
Only ever fi ll the water reservoir (6) with fresh, clear tap water. Do not pour in any
other liquids.
3. Take off the lid (15) (see the "Removing / Attaching the Lid" section).
4. Pour the desired quantity of water (maximum 5 litres) into the water reservoir. Note the
MAX marking.
5. Close the lid (see the "Removing / Attaching the Lid" section).
Operating the Discharge Tap
1. Press down the lever (14) and keep it pressed down. The discharge tap (13) opens
and water fl ows out (Illustration B).
2. Let go of the lever when the quantity of water you want has been removed. The dis-
charge tap closes again.
Preparation
NOTE
• Do not operate the device without water. If this does happen, the heating
element of the device switches off automatically (protection against running
dry). The dry-running protection control lamp will light up. In this case, allow the
device to cool down for around 5 – 10 minutes before water is poured in and
the device is used again.
If water needs to be added, switch off the device, pull the mains plug out of the
plug socket and allow the device to cool down for a few minutes. When opening the
lid (15), use potholders or similar gloves and be careful.
28