Installation and operating manual
7.6
Operation using the hand crank
Hoists for manual emergency operation with hand crank may only be operated with the hand crank in emergencies (power failure,
rescue).
Illustration 24
–
Abide by the safety instructions given in § 7.
7.6.1 Move the hand crank to the operating position
–
Pull out of the cotter pin (1).
–
Turn the hand crank (2) and push it onto the holder on the axle.
The switch (3) is activated when the hand crank is in the operating position. The power supply is shut off.
–
Insert the cotter pin (1) into the fixing bolt (4) in front of the fixing plate (5).
The hand crank is locked in the operating position.
7.6.2 Operation
–
Pull the lever (6) out of the carrying handle (7).
–
Insert the lever (6) into the brake bracket through the slot in the hood of the motor.
–
Lift and hold the lever.
–
Raise or lower the load by turning the hand crank (2).
7.6.3 Move the hand crank to the idle position
–
Pull out of the cotter pin (1).
–
Pull the hand crank (2) out of the holder on the axle.
EN-44
G1035.4 – 01/2019