Edirol AUDIOCAPTURE UA-5 Démarrage page 54

Troubleshooting
Driver is not installed correctly
• The Power indicator may be blinking.
• The ADVANCE (mode select) switch may have been turned OFF when the Sampling
frequency select switch is set to 96 kHz.
If you are using the UA-5 at 96 kHz, turn the ADVANCE (mode select) switch ON.
As described in Deleting the special driver (p. 63), delete the USB audio device driver
that is installed in your computer, and then install the UA-5 driver once again as
described in Getting Connected and Installing Drivers (Windows) (p. 15). Also check
whether there is an "Unknown device" in "Other devices" or "Universal Serial Bus
Controller."
If you find one, delete it.
Can't install/delete/use the special driver in Windows
2000
• Did you log on to Windows as a user with administrative privileges?
In order to install/delete/re-install the special driver in Windows 2000, you must be
logged into Windows as a user with administrative privileges, such as Administrator.
For details, please contact the system administrator for your computer system.
• Did you make "Driver signature settings"?
In order to install/re-install the driver, you must make "File signature settings."
Make settings as described in Installing the special driver (p. 16).
Windows 2000 displays a "Digital signature was not
found" dialog box
• Did you perform the steps in "Make file signature settings"?
In order to install/re-install the driver, you must make the settings described in "File
signature settings." Use the following procedure to check the settings.
1.
Open the Control Panel, and double-click System.
2.
Click the Hardware tab, and then click [Driver signature] button. The
"Driver Signing Options" dialog box will appear.
3.
Make sure that the "File signature verification" setting is "Ignore." If it is set
to "Ignore," click the [OK] button. If not, make a note of the current setting,
change it to "Ignore," and then click the [OK] button.
54