Edirol AUDIOCAPTURE UA-5 Démarrage page 38

Getting Connected and Installing Drivers (Macintosh)
Installing the OS-standard driver
1
With the UA-5 disconnected, start up Mac OS.
2
Exit all currently running software (applications).
If you are using a virus checker or similar software, be sure to
exit it as well.
fig.05-35e_30
3
After starting up Mac OS, select
Apple System Profiler from the
Apple menu.
The "Apple System Profiler" dialog box will appear.
4
Click the Devices and Volumes tab.
5
With the power turned off, use a USB cable to
connect the UA-5 to your Macintosh.
6
Place the UA-5's ADVANCE (mode select) switch
in the OFF position.
7
Switch ON the UA-5's Power switch.
Connect the AC adaptor to the UA-5's AC adaptor jack, and
insert the AC adaptor's plug into an AC power outlet. Then,
turn on the power of the UA-5.
8
Wait for approximately five seconds.
The UA-5 will use the driver included with Mac OS.
While you are waiting, the screen display will not change, but
the UA-5 is being detected. Do not touch the mouse or
keyboard.
38
This unit is equipped with a
protection circuit. A brief
interval (a few seconds) after
power up is required before
the unit will operate normally.