Edirol AUDIOCAPTURE UA-5 Démarrage page 25

Installing the OS-standard driver
The procedure for installation and settings will depend on
your system.
Proceed to the appropriate section as follows.
• Windows 2000 users..................................(p. 25)
• Windows Me users ....................................(p. 26)
• Windows 98 users......................................(p. 27)
Windows 2000 users
1
Start up Windows.
2
Exit all currently running software (applications).
If you are using a virus checker or similar software, be sure to
exit it as well.
3
Use a USB cable to connect the UA-5 to your
computer.
4
Place the UA-5's mode select switch in the OFF
position.
5
Turn on the power of the UA-5.
Connect the AC adaptor to the UA-5's AC adaptor jack, and
insert the AC adaptor's plug into an AC power outlet. Then,
turn on the power of the UA-5.
The UA-5 will be detected automatically, and the driver will
be installed.
6
When installation is complete, restart Windows.
Next, you will need to make the driver settings.
(–>Settings and checking (p. 30))
Getting Connected and Installing Drivers (Windows)
This unit is equipped with a
protection circuit. A brief
interval (a few seconds) after
power up is required before
the unit will operate normally.
25