Edirol AUDIOCAPTURE UA-5 Démarrage page 13

Rear panel
fig.04-2
26
15. USB connector
Connect your computer here via a USB cable. Do not connect or disconnect the USB
cable while an audio playback application is recording or playing. Doing so may
cause the application to hang up.
16. ADVANCE (mode select) switch
This switches the operating mode.
In order for the settings to take effect, you must exit all applications and turn on the
power of the UA-5 once again.
On (Advanced mode)
The driver included with the UA-5 will be used to record/play/edit audio on
sequencer software or waveform editing software with high audio quality and
stable timing.
Off (Standard Driver mode)
Select this mode when using applications that use the audio driver included with
your operating system, and utilize functionality specific to your operating system.
For details on the operating mode, refer to Advanced mode and Standard Driver
mode (Windows–> p. 15 / Macintosh–> p. 34).
17. Digital input connector (coaxial)
Connect a coaxial cable here when you want to digitally input an audio signal from
a device such as a CD/MD/DAT.
18. Digital output connector (coaxial)
Connect a coaxial cable here when you want to digitally output an audio signal to
a digital recorder such as an MD or DAT.
19. Digital input select switch
This selects whether the coaxial or optical connector will be used for digital input.
20. Digital input connector (optical)
Connect an optical cable here when you want to digitally input an audio signal from
a device such as a CD/MD/DAT.
24 23
25
Names of things and what they do
22 21 19
20
17
18 16 15
13