Edirol AUDIOCAPTURE UA-5 Démarrage page 27

10
Restart Windows.
Next, you will need to make the driver settings.
(–> Settings and checking (p. 30))
Windows 98 users
The USB composite device driver is installed first, then the
USB audio device driver is installed. Use the following
procedure to install the drivers.
1
Start up Windows.
2
Exit all currently running software (applications).
If you are using a virus checker or similar software, be sure to
exit it as well.
3
Insert the Windows CD-ROM into the CD-ROM
drive.
4
Use a USB cable to connect the UA-5 to your
computer.
5
Set the UA-5's mode select switch to the OFF
position.
6
Turn on the power of the UA-5.
Connect the AC adaptor to the UA-5's AC adaptor jack, and
insert the AC adaptor's plug into an AC power outlet. Then,
turn on the power of the UA-5.
Getting Connected and Installing Drivers (Windows)
Depending on your system, a
certain amount of time may be
required for the device to be
detected after the driver has
been installed.
Some computers are sold with
the contents of the Windows
CD-ROM already on the hard
disk, and may not come with a
Windows CD-ROM. In this
case, you will be able to install
the drivers even without the
Windows CD-ROM.
This unit is equipped with a
protection circuit. A brief
interval (a few seconds) after
power up is required before
the unit will operate normally.
27