Edirol AUDIOCAPTURE UA-5 Démarrage page 44

UA-5 application guide
Recording from a mic
Dynamic Mic
fig.mic.e
INPUT
Adjust the
input level.
fig.mic-con.e
When using a condenser mic, turn on the Phantom power switch.
* If a device that does not require phantom power is connected to the XLR jacks, you must
turn off the Phantom power switch to avoid malfunction.
The sound of the device connected to Input jack 1 will be recorded on the left
channel, and the sound of the device connected to Input jack 2 will be recorded on
the right channel.
Use the Input sensitivity knob to adjust the input level. For optimum recording
quality, adjust the input sensitivity knob so it is as high as you can get it without
causing the Peak indicator to light.
Turn on the Input monitor switch, and use the Input monitor volume button to
adjust the monitor volume of the mic input. You can use the Input monitor stereo/
mono select button to switch the monitoring of the mic input between STEREO/
MONO.
* When recording from a microphone, acoustic feedback (a whining or howling sound)
may occur, depending on the position of the microphone relative to the speakers. If this
occurs, you can take the following measures.
1.Change the angle of the microphone
2.Move the microphone away from the speakers
3.Lower the volume
44
Signal flow
Microphone
Record in stereo
Record in monaural
Off
Turn on if you
want to monitor.
Condenser Mic
Condenser
Microphone
INPUT
On
Adjust the
input level.
Signal flow
Record in stereo
Record in monaural
Turn on if you
want to monitor.