Edirol AUDIOCAPTURE UA-5 Démarrage page 46

UA-5 application guide
Recording from the AUX input
fig.aux.e
Use the Input jacks 3 and 4 adjustment volume to adjust the input level. For
optimum recording quality, use the AUX input adjustment volume to raise the level
so it is as high as you can get it before causing the Peak indicator to light.
Turn on the Input monitor switch, and use the Input monitor volume button to
adjust the monitor volume.
Turn down the Input sensitivity knob all the way to the left.
Do not connect anything to Input jacks 1 and 2.
Be careful of looped connections
Looped connections
fig.loop.e
If the UA-5 is connected as shown above to a device that outputs ("thru-s") the
input audio (such as an MD or DAT that is in record mode), turning on the Input
monitor switch will cause the sound to loop between the UA-5 and the other
device, causing oscillation and producing an unexpectedly high volume. Be aware
that such connections may cause the system to malfunction, or your speakers to
be damaged.
46
Signal flow
INPUT
UA-5
LINE IN
LINE OUT
Turn on if you
want to monitor.
OUTPUT
MIDI Sound Module
Stereo Set
Loop Connection
LINE OUT
LINE IN
Stereo Set
(MD/DAT)