Edirol AUDIOCAPTURE UA-5 Démarrage page 26

Getting Connected and Installing Drivers (Windows)
Windows Me users
1
Start up Windows.
2
Exit all currently running software (applications).
If you are using a virus checker or similar software, be sure to
exit it as well.
3
Use a USB cable to connect the UA-5 to your
computer.
4
Place the UA-5's mode select switch in the OFF
position.
5
Turn on the power of UA-5.
Connect the AC adaptor to the UA-5's AC adaptor jack, and
insert the AC adaptor's plug into an AC power outlet. Then,
turn on the power of the UA-5.
fig.05-23e_30
6
Windows will detect the
UA-5, and the "Add new
hardware wizard" dialog
box will appear.
Make sure that
Automatically search for
the appropriate driver
(Recommended) is selected, and click [Next].
7
Driver detection will begin.
8
When the driver has been found, driver installation
will begin.
fig.05-24e_30
9
Once the driver has
been installed, a dialog
box will inform you of
this.
Click [Finish].
26
This unit is equipped with a
protection circuit. A brief
interval (a few seconds) after
power up is required before
the unit will operate normally.