Edirol AUDIOCAPTURE UA-5 Démarrage page 40

Getting Connected and Installing Drivers (Macintosh)
fig.05-45e_30
2
Click the Speaker tab or
Speaker Settings.
xfig.05-46e_30
3
With the volume turned down
on the UA-5 and on your
peripheral audio equipment,
click Start test.
Test signals will be output from the
UA-5; left first, then right, as
indicated in the screen.
4
In the Sound dialog box, click the Input tab.
In Select sound input source (device), select USB audio.
* Do not check "Play back sound via output device".
fig.05-49e_30
5
When you are finished
making settings, close the
Sound dialog box.
From the File menu, select Exit.
40
If USB audio is not displayed,
close the "Sound" dialog box,
and disconnect the UA-5's USB
cable from the Macintosh.
Perform the driver installation
(p. 38) once again.