Edirol AUDIOCAPTURE UA-5 Démarrage page 48

UA-5 application guide
Digitally recording the output of the UA-5 on
an MD
Make connections as shown in the diagram.
fig.MD.e
Set the UA-5's Sampling frequency select switch to match the sampling
frequency that can be recorded on your recording device (e.g., MD). However, be
aware that the sampling frequency setting of your application must also be set to
the same setting.
* The UA-5 does not support audio formats of professional digital devices.
On the UA-5, the input from the input jacks or the input signal from the Digital
input connector cannot be output directly to the Digital output connector. The
Digital output connector will always output only the audio signal from the
computer.
48
Signal flow
Set to the appropriate sampling
frequency, so it matches the audio
data to be played back, or the
application you intend to use.
DIGITAL
OUT
Optical digital
cable
MD
DIGITAL
INPUT