Edirol AUDIOCAPTURE UA-5 Démarrage page 35

If you want to use the UA-5 in Advanced mode, proceed to Installing the special
driver (p. 35). If you want to use Standard driver mode, proceed to Installing the
OS-standard driver (p. 38).
Switching between Advanced mode and Standard driver mode
If you first install both the special driver and the standard driver, you will be able
to switch between Advance and Standard driver modes by operating the UA-5's
ADVANCE (mode select) switch.
* In order for the setting of the ADVANCE (mode select) switch to
take effect, you must exit all sequencer software and other
applications that use the UA-5, switch off the UA-5, then turn it
back on again
Installing the special driver
Installing the audio driver
1
Exit all currently running software (applications).
If you are using a virus checker or similar software, be sure to
exit this as well.
2
Prepare the CD-ROM.
Insert the UA-5 Driver CD-ROM into the CD-ROM drive.
fig.05-18e_30
3
Double-click the UA-5 USB
Installer E icon (found in the
Driver folder of the CD-ROM).
fig.05-19e_30
4
Verify the installation
location, and click
[Install].
Getting Connected and Installing Drivers (Macintosh)
The location for installation
will depend on your system.
Make sure that the startup disk
for the system you are
currently using is selected.
35