Names Of Things And What They Do - Edirol AUDIOCAPTURE UA-5 Démarrage

Names of things and what they do

Front panel
fig.04-1
1. Input jacks 1, 2
Phone type
(Unbalanced)
1:GND
2:HOT
3:COLD
* Unless condenser mics requiring phantom power are connected, you must be sure to turn
the Phantom power switch off (dark). Supplying phantom power to a dynamic mic or audio
playback device will cause malfunction. For details on your type of mic, refer to the manual
that came with your mic. (The phantom power supply of the UA-5 is DC 48V, maximum
10mA.)
2. Input sensitivity knobs
These adjust the sensitivity of Input jacks 1 and 2. The jack will be at mic level (-50
dBv) when the knob is turned fully right, and at line level (0 dBv) when turned fully
left.
10
1
2
fig.04-1ae
These are input jacks for analog audio signals. These
are combination XLR and phone jacks, allowing you to
XLR type
connect either type of plug. Both balanced and
unbalanced devices can be connected. The XLR-type
connections support 48 V phantom power, allowing
TRS
phantom powered condenser mics to be connected. In
phone type
(Balanced)
this case, turn the Phantom power switch on (lit).
GND(SLEEVE)
HOT(TIP)
COLD(RING)
3 5 6
4
fig.04-1b
The UA-5 has balanced (XLR/TRS)
type input jacks. The pin connections
of connectors are shown below. Before
making connections, please check the
pin connections of the device you are
connecting.
8 11
7 9 10 12
13
14