Adjusting Voltage With The Rheostat; Emergency Stop Switch - Wacker Neuson G 100 Notice D'emploi

Operation
4.7

Adjusting Voltage with the Rheostat

Location and The voltage adjustment rheostat (b) is located directly to the right of the metering
description
panel. Use the rheostat to adjust the AC voltage output.
R
Operation To adjust the AC voltage output:
Turn the adjusting knob clockwise to increase the voltage output.
Turn the adjusting knob counterclockwise to decrease the voltage output.
Monitor the voltage at the LCD panel.
4.8

Emergency Stop Switch

Location The emergency stop switch is activated by pressing the red button located to the
left of the control panel. The button can be accessed with the panel doors closed. It
is electrically isolated from the switch and also from the rest of the metering panel.
Operation Activate the emergency stop switch by pressing the red button.
Activating the emergency stop switch opens the main circuit breaker and the
fuel solenoid, and results in the engine shutting down.
The switch will remain activated until the button is pulled out.
NOTICE: Press the emergency stop button only in the case of an actual
emergency where the generator must be stopped immediately! In all other
instances, open the main line circuit breaker and then turn the engine start switch
to off "O".
Ø A HZ
V
REMOTE START REMOTE START
DIAGNOSTICS
DIAGNOSEN ARRANQUE REMOTO ARRANQUE REMOTO
DEMARRAGE A DEMARRAGE A
DIAGNOSTICOS
DIAGNOSTICS
wc_gr005202
OFF OFF
AUS AUS
APAGADO APAGADO
ARRET ARRET
START / RUN START / RUN
FERNSTART FERNSTART START / LAUFEN START / LAUFEN
ARRANQUE / MARCHA ARRANQUE / MARCHA
DEMARRER / MARCHE DEMARRER / MARCHE
DISTANCE DISTANCE
b
40
G 100 / G 120
wc_tx001687gb.fm