Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
G 100 / G 120
Licensing requirements
Coupler maintenance
Towing safety
wc_tx001191gb.fm
•
Make sure that the hitch and coupler are compatible. The
generator trailer is equipped with a pintle type coupler (a).
•
Check that the directional and running lights on the trailer are
working.
•
Connect the safety chains (c) using a crossed pattern under the
trailer tongue.
•
On trailers with surge or electric brakes, connect the breakaway
cable (b) on the trailer coupler to the rear bumper or frame of the
vehicle. This cable will actuate the brake system on the trailer if
both the coupling and safety chains have failed. The breakaway
cable is not a parking brake and should not be used as one.
•
Check that all fasteners on the coupling are secure.
•
Check the tread wear and inflation on the tires. Make sure that all
lug nuts are in place and are tight.
•
Check the operation of the brakes by braking the vehicle at a
slow speed before entering traffic. Both the vehicle and the trailer
should brake smoothly. If the trailer seems to be pushing, check
the fluid level in the surge brakes or the operation of the electric
brakes.
•
In most states, large trailers must be registered and licensed by
the State Department of Transportation. Before towing, be sure to
check licensing requirements.
•
Drivers towing trailers may be required to carry a commercial
driver's license (CDL). Check your local and state licensing
regulations before towing the generator.
•
A film of grease on the coupler will extend coupler life and
eliminate squeaking. Wipe the coupler clean and apply fresh
grease each time the trailer is towed.
•
When towing, maintain extra space between vehicles and avoid
soft shoulders, curbs and sudden lane changes. If you have not
pulled a trailer before, practice turning, stopping, and backing up
in an area away from heavy traffic.
•
Do not exceed 55 mph when towing a trailer.
Lifting and Transporting
31
Publicité
Chapitres
Table des Matières
