Changing User Preferences - Wacker Neuson G 100 Notice D'emploi

Mobile Generator
5.5

Changing User Preferences

5.5.1
5.5.2
5.5.3
5.5.4
5.5.5
5.5.6
5.5.7
5.5.8
wc_tx001182gb.fm
Changing Display Units
The LCD panel can be configured by the operator to display system
information in either metric units or English units.
To access the main menu, press the right arrow button (1) on the
keypad (g).
Note: If there are active alarms or pre-alarms, press the left arrow button (4)
three times to access the main menu.
Using the up/down arrow buttons (2,3), select SETTINGS and press
the right arrow button.
Select SYSTEM PARAMETERS. Press the right arrow button.
Select SYSTEM SETTINGS. Press the right arrow button
Select SYSTEM UNITS. Press the check mark button (5).
If necessary, enter your password. (See Entering Passwords for more
information.)
Select either METRIC or ENGLISH (default). Press the check mark
button.
Exit by repeatedly pressing the left arrow until the LCD panel display
returns to monitoring status.
Changing System Language
Many of the default English monitoring display and menu selections
can be changed to other languages. However, this reconfiguration
cannot be performed by the operator. Please contact your Wacker
Neuson representative if you wish to have the LCD panel display and
menu selections appear in a language other than English.
Note: Not all display and menu selections can be changed from the default
English. Refer to "Navigating the Menus" for translations if necessary.
Using the LCD Panel and Keypad
63