Engine Start Switch - Wacker Neuson G 100 Notice D'emploi

Operation
4.3

Engine Start Switch

Location and The engine start switch (f) is located on the right side of the control panel. It is a
description
three-position switch: "REMOTE START," off "O," and "START/RUN."
R
Operation REMOTE START position:
The REMOTE START position is the normal setting when the generator is being
operated as a back-up power supply connected to a remote switch.
In the REMOTE START position, the generator is in standby mode and will not
start until the remote switch closes.
START/RUN position:
In the START/RUN position, the switch immediately launches the engine start
cycle and activates the starter motor to crank the engine.
Off "O" position:
In the off "O" position, power to the engine's electrical system, including the fuel
solenoid, is disconnected.
Note: When set in the REMOTE START or START/RUN position, the engine start
switch applies battery power to the control module to turn on the LCD panel, and
also energizes the engine's electrical system.
V Ø A HZ
REMOTE START REMOTE START
DIAGNOSTICS FERNSTART FERNSTART
DIAGNOSEN ARRANQUE REMOTO ARRANQUE REMOTO
DEMARRAGE A DEMARRAGE A
DIAGNOSTICOS
DIAGNOSTICS DISTANCE DISTANCE
f
OFF OFF
AUS AUS
APAGADO APAGADO
ARRET ARRET
START / RUN START / RUN
START / LAUFEN START / LAUFEN
ARRANQUE / MARCHA ARRANQUE / MARCHA
DEMARRER / MARCHE DEMARRER / MARCHE
36
G 100 / G 120
wc_tx001687gb.fm