Changing Cooldown Time - Wacker Neuson G 100 Notice D'emploi

Mobile Generator
5.7

Changing Cooldown Time

See graphic: wc_gr005938
5.7.1
5.7.2
5.7.3
5.7.4
5.7.5
5.7.6
5.7.7
5.7.8
wc_tx001182gb.fm
A cooldown timer activates when the machine is no longer receiving a
remote run signal. This timer is factory set to zero (0) minutes. The
cooldown time can be changed if desired.
To access the main menu, press the right arrow button (1) on the
keypad (g).
Note: If there are active alarms or pre-alarms, press the left arrow (4)
three times to access the main menu.
Using the up/down arrow buttons (2,3), select SETTINGS and press
the right arrow button.
Select SYSTEM PARAMETERS. Press the right arrow button.
Select CRANK SETTINGS. Press the right arrow button
Select COOLDOWN TIME. Press the check mark button (5).
If necessary, enter your password. (See Entering Passwords for more
information.)
Use the up/down arrow buttons to change the default value. Press the
check mark to accept the change, or the reset button (6) to cancel.
Exit by repeatedly pressing the left arrow button until the LCD panel
display returns to monitoring status.
Using the LCD Panel and Keypad
65