Entering Passwords - Wacker Neuson G 100 Notice D'emploi

Using the LCD Panel and Keypad
5.2

Entering Passwords

See graphic: wc_gr006068
5.2.1
5.2.2
5.2.3
5.2.4
5.2.5
5.2.6
Some configuration procedures require a password to be entered
before changes can be made. Once a password has been entered, it
remains in the memory until the machine is shut off.
Note: The default password is OP and is set by the factory. Contact
your Wacker Neuson dealer if you need to have the password reset.
Follow the steps below to enter a password.
The password entry screen appears with a blinking letter "A" as the
default character. Use the up/down buttons (2,3) to change the "A" to
the correct letter or number.
When the correct letter or number appears, press the right arrow
button (1) to enter the character and move to the next position.
Use the up/down buttons to select the next character in the password,
and press the right arrow button. Continue selecting and entering
characters until the password is complete.
To return to a previous character, press the left arrow button (4).
When the password is complete, press the check mark button (5) to
enter the password and log into the configuration menu.
To clear a password and re-enter it, press the "X" button (6).
Mobile Generator
60
wc_tx001182gb.fm